Please wait a minute...
 
材料工程  2019, Vol. 47 Issue (7): 112-120    DOI: 10.11868/j.issn.1001-4381.2018.000455
  研究论文 本期目录 | 过刊浏览 | 高级检索 |
Ti60钛合金室温保载疲劳性能及断裂行为
刘石双1,2, 仇平1, 蔡建明2, 李娟2, 黄旭2, 于辉1, 刘利刚1
1. 燕山大学 先进锻压成形技术与科学教育部重点实验室, 河北 秦皇岛 066004;
2. 中国航发北京航空材料研究院 先进钛合金航空科技重点实验室, 北京 100095
Dwell fatigue property and fracture behaviour of Ti60 titanium alloy at room temperature
LIU Shi-shuang1,2, QIU Ping1, CAI Jian-ming2, LI Juan2, HUANG Xu2, YU Hui1, LIU Li-gang1
1. Key Laboratory of Advanced Forging & Stamping Technology and Science of Ministry of Education, Yanshan University, Qinhuangdao 066004, Hebei, China;
2. Aviation Key Laboratory of Science and Technology on Advanced Titanium Alloys, AECC Beijing Institute of Aeronautical Materials, Beijing 100095, China
全文: PDF(17697 KB)   HTML()
输出: BibTeX | EndNote (RIS)      
摘要 研究高峰值应力条件下Ti60钛合金双态组织和片层组织的低周疲劳与保载疲劳性能,利用金相显微镜(OM)、扫描电子显微镜(SEM)和电子背散射衍射(EBSD)等观察和分析Ti60钛合金的显微组织与疲劳断裂行为。结果表明:显微组织对低周疲劳性能影响不大,但显著影响保载疲劳性能,双态组织保载疲劳敏感性大于片层组织;保载情况下,疲劳寿命显著下降;随峰值应力的提高,疲劳寿命下降,保载疲劳敏感性增加;相同循环周次内,保载疲劳塑性应变累积大于低周疲劳,双态组织的塑性应变累积大于片层组织;低周疲劳裂纹萌生于试样表面,为单裂纹源,而保载疲劳裂纹为内部多源萌生;断口表面均存在准解理小平面,双态组织断口准解理小平面密度大于片层组织。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
刘石双
仇平
蔡建明
李娟
黄旭
于辉
刘利刚
关键词 Ti60钛合金保载疲劳保载疲劳敏感性塑性应变累积准解理小平面    
Abstract:The low cycle fatigue (LCF) property and low cycle dwell fatigue (LCDF) property of bimodal structure and lamellar structure for Ti60 titanium alloy under high peak stress were studied by means of optical microscope (OM), scanning electron microscope (SEM) and electron backscatter diffraction (EBSD). The results show that microstructure has little effect on LCF property, while significantly influences LCDF property. The dwell fatigue sensitivity of bimodal structure is higher than that of lamellar structure. Under dwell loading condition, the fatigue life decreases remarkably. The fatigue life decreases with the increase of the peak stress, while the dwell fatigue sensitivity increases. Within the same cycle, plastic strain accumulation of LCDF is greater than that of LCF, and the plastic strain accumulation of bimodal structure is more than that of lamellar structure. The LCF crack initiates at the specimen surface with single source, while LCDF crack originates inside of specimen with multiple sources. There are quasi-cleavage facets on the fracture surface. The density of facets for bimodal structure is higher than that of lamellar structure.
Key wordsTi60 titanium alloy    dwell fatigue    dwell fatigue sensitivity    plastic strain accumulation    quasi-cleavage facet
收稿日期: 2018-04-23      出版日期: 2019-07-19
中图分类号:  TG146.2+3  
通讯作者: 仇平(1969-),男,博士,教授,研究方向:金属材料加工工程,联系地址:河北省秦皇岛市海港区燕山大学先进锻压成形技术与科学教育部重点实验室(066004),qiuping@ysu.edu.cn     E-mail: qiuping@ysu.edu.cn
引用本文:   
刘石双, 仇平, 蔡建明, 李娟, 黄旭, 于辉, 刘利刚. Ti60钛合金室温保载疲劳性能及断裂行为[J]. 材料工程, 2019, 47(7): 112-120.
LIU Shi-shuang, QIU Ping, CAI Jian-ming, LI Juan, HUANG Xu, YU Hui, LIU Li-gang. Dwell fatigue property and fracture behaviour of Ti60 titanium alloy at room temperature. Journal of Materials Engineering, 2019, 47(7): 112-120.
链接本文:  
http://jme.biam.ac.cn/CN/10.11868/j.issn.1001-4381.2018.000455      或      http://jme.biam.ac.cn/CN/Y2019/V47/I7/112
[1] 蔡建明,李臻熙,马济民,等. 航空发动机用600℃高温钛合金的研究与发展[J]. 材料导报, 2005, 19(1):50-53. CAI J M, LI Z X, MA J M, et al. Research and development of 600℃ high temperature titanium alloys for aeroengine[J]. Mater-ials Review, 2005, 19(1):50-53.
[2] 蔡建明,弭光宝,高帆,等. 航空发动机用先进高温钛合金材料技术研究与发展[J]. 材料工程, 2016, 44(8):1-10. CAI J M, MI G B, GAO F, et al. Research and development of some advanced high temperature titanium alloys for aero-engine[J]. Journal of Materials Engineering, 2016, 44(8):1-10.
[3] 蔡建明,田丰,刘东,等. 600℃高温钛合金双性能整体叶盘锻件制备技术研究进展[J]. 材料工程, 2018, 46(5):36-43. CAI J M, TIAN F, LIU D, et al. Research progress in manufa-cturing technology of 600℃ high temperature titanium alloy dual property blisk forging[J]. Journal of Materials Engineering, 2018, 46(5):36-43.
[4] WILLIAMS J C, STARKE E A Jr. Progress in structural materials for aerospace systems[J]. Acta Materialia, 2003, 51(19):5775-5799.
[5] BACHE M R. A review of dwell sensitive fatigue in titanium alloys:the role of microstructure, texture and operating condit-ions[J]. International Journal of Fatigue, 2003, 25(9/11):1079-1087.
[6] 王清江,刘建荣,杨锐. 高温钛合金的现状与前景[J]. 航空材料学报, 2014, 34(4):1-26. WANG Q J, LIU J R, YANG R. High temperature titanium alloys:status and perspective[J]. Journal of Aeronautical Materials, 2014, 34(4):1-26.
[7] WANG X, JAHAZI M, YUE S. Substructure of high tempe-rature compressed titanium alloy IMI834[J]. Materials Science and Engineering:A, 2006, 434(1/2):188-193.
[8] THOMSEN M L, HOEPPNER D W. The effect of dwell loading on the strain accumulation behavior of titanium alloys[J]. Inter-national Journal of Fatigue, 1998, 20(4):309-317.
[9] SONG Z, HOEPPNER D W. Dwell time effects on the fatigue behavior of titanium alloys[J]. International Journal of Fatigue, 1988, 10(4):211-218.
[10] McBAGONLURI F, AKPAN E, MERCER C, et al. An investigation of the effects of microstructure on dwell fatigue crack growth in Ti-6242[J]. Materials Science and Engineering:A, 2005, 405(1/2):111-134.
[11] 杨丽娜,刘建荣,陈志勇,等. 加载波形对Ti-60合金疲劳损伤行为的影响[J]. 中国有色金属学报, 2010, 20(专辑1):487-490. YANG L N, LIU J R, CHEN Z Y, et al. Effect of loading waveform on fatigue damage behavior of Ti-60 alloy[J]. The Chinese Journal of Nonferrous Metals, 2010, 20(Special 1):487-490.
[12] EVANS W J, GOSTELOW C R. The effect of hold time on the fatigue properties of a β-processed titanium alloy[J]. Metall-urgical Transactions A, 1979, 10(12):1837-1846.
[13] KASSNER M E, KOSAKA Y, HALL J A. Low-cycle dwell-time fatigue in Ti-6242[J]. Metallurgical and Materials Transactions A, 1999, 30(9):2383-2389.
[14] EVANS W J, BACHE M R. Dwell-sensitive fatigue under biaxial loads in the near-alpha titanium alloy IMI685[J]. International Journal of Fatigue, 1994, 16(7):443-452.
[15] PENG J, ZHOU C Y, DAI Q, et al. Dwell fatigue and cycle deformation of CP-Ti at ambient temperature[J]. Materials & Design, 2015, 71:1-16.
[16] BACHE M R, EVANS W J, DAVIES H M. Electron back scattered diffraction (EBSD) analysis of quasi-cleavage and hydrogen induced fractures under cyclic and dwell loading in titanium alloys[J]. Journal of Materials Science, 1997, 32(13):3435-3442.
[17] BACHE M R, COPE M, DAVIES H M, et al. Dwell sensitive fatigue in a near alpha titanium alloy at ambient temperature[J]. International Journal of Fatigue, 1997, 19(93):83-88.
[18] YANG L N, LIU J R, TAN J, et al. Dwell and normal cyclic fatigue behaviours of Ti60 alloy[J]. Journal of Materials Science and Technology, 2014, 30(7):706-709.
[19] EYLON D, HALL J A. Fatigue behavior of beta processed titanium alloy IMI685[J]. Metallurgical Transactions A, 1977, 8(6):981-990.
[1] 蔡建明, 李臻熙, 曹春晓, 黄旭, 雷强, 张元伟. Ti60钛合金中富钕稀土相颗粒对叶片室温振动疲劳性能的影响[J]. 材料工程, 2007, 0(8): 57-60.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
版权所有 © 2015《材料工程》编辑部
地址:北京81信箱44分箱 邮政编码: 100095
电话:010-62496276 E-mail:matereng@biam.ac.cn
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn