高强高韧钢23CoNi连续相变及奥氏体逆转变研究

王六定

材料工程 ›› 1999, Vol. 0 ›› Issue (12) : 28-30.

PDF(163 KB)
PDF(163 KB)
材料工程 ›› 1999, Vol. 0 ›› Issue (12) : 28-30.
论文

高强高韧钢23CoNi连续相变及奥氏体逆转变研究

  • 王六定
作者信息 +

Investigation of Continuous Transformation and Austenitic Reverted Transition for 23CoNi Steel with High Strength and Fracture Toughness

  • WANG Liu-ding
Author information +
文章历史 +

摘要

有关高强高韧钢23CoNi回火后微观组织与力学性能研究已有一些报道,但对该钢在过程中各种碳化物的形成机理与微观组织的演变规律等问题仍不甚清楚。本工作主要研究23CoNi钢在回火早期阶段通过调幅分解形成溶质原子的贫化区和富化区,并进一步探讨了回火中期逆转变奥氏体的形成规律。

Abstract

Although some experimental investigation of microcosmic tissue and mechanical properties for ultrahigh-strength steel 23CoNi has been reported, there are still pome problems that are not clear on the formation mechanism of several kinds of carbides and the evolving law of microcosmic tissue in the course of tempering Thus, the paper focuses mainly on the investigation of the modulated structure, i.e. the depleted and rich regions, formed through spinodal decomposition at the early stage of tempering for 23CoNi steel, and delves further into the formation law of reverted austenite in the mid-period of tempering.

关键词

超高强度钢 / 调幅分解 / 逆转变奥氏体

Key words

ultrahigh strength steel / spinodal decomposition / reverted austenite

引用本文

导出引用
王六定. 高强高韧钢23CoNi连续相变及奥氏体逆转变研究[J]. 材料工程, 1999, 0(12): 28-30
WANG Liu-ding. Investigation of Continuous Transformation and Austenitic Reverted Transition for 23CoNi Steel with High Strength and Fracture Toughness[J]. Journal of Materials Engineering, 1999, 0(12): 28-30
中图分类号: TG142.1   

参考文献

[1] R.Ayer and P. M. Machmeier.Transformation Electron Microscopy of Hardening and Toughening Phenomena in Aermet 100[J]. Metall. Trans., 1993, 24A:1943.
[2] 凌斌,钟平,钟炳文,古宝珠. Ni10Co14 钢的二次硬化过程的TEM观察[J]. 金属学报,1995,31(5):A209~215.
[3] 耿平,曾梅光,晁月盛,钱存富.新型高强高韧钢99的穆斯堡尔谱研究[J].金属热处理学报,1998,19(3):58~63.
[3] 耿平,曾梅光,晁月盛,钱存富.新型高强高韧钢99的穆斯堡尔谱研究[J].金属热处理学报,1998,19(3):58~63.
[4] K. J. Handerhan, W. M. Garrison and N. R. Moody. A Comparison of the Fracture Behavior of Two Heats of the Secondary Hardening Steel AF 1410[J]. Metall. Trans., 1989, 20A:105.
[5] W. M. Garrison and N. R. Moody. The Influence of Inclusion Spacing and Microstructure on the Fracture Toughness of the Secondary Hardening Steel AF 1410[J]. Metall. Trans., 1987, 18A:1257.
[6] 卫英慧. 博士论文. 合金连续相变调幅分解与有序化规律的研究[J]. 西安交通大学,西安. 1997. 1.
[7] 凌斌,钟平,钟炳文,赵振亚,张少卿. 新型二次硬化高Co-Ni超高强度钢强韧化机制研究[J]. 航空学报,1997,18(1):44~49.
[8] 凌斌. 博士论文. 高合金超高强度钢的微观组织及强韧化机制的研究[J]. 航空材料研究院,北京. 1996.
[9] Wang Liuding et al. Spinodal Decomposition of Ultrahigh-Strength Steel 23Co14Ni12Cr3[J]. J. Mater. Sci. Technol., to be published.
[10] M. Miyazaki, S. Takagishi, H. Mori and T. Kozakai. The Phase Decomposition of Iron-Molybdenum Binary Alloy by Spinodal Mechanism[J]. Acta Metall., 1980, 28:1143.
[11] 王六定等. 一种超高强度钢热滞回线及其异常平台研究[J]. 金属热处理学报,1998,19(4):49~54.
[12] 沈嵘.博士论文.贝氏体相变机制的理论及实验研究[J]. 西北工业大学,西安. 1998. 4.
[13] 王六定. 23Co14Ni12Cr3 钢等温奥氏体形成动力学[J]. 材料科学与工艺,1998,6(2):98~102.

基金

航空基础科学基金(96G53084)
PDF(163 KB)

858

Accesses

0

Citation

Detail

段落导航
相关文章

/